Thermok Configuration Page - APRS World, LLC

	Thermok Configuration Page
Home	Products	Ordering Information	Order Tracking	Photo Gallery	Live Data Sites	Contact Information

Using the form below you can generate a custom Thermok firmware image. You can then follow our bootloading instructions to download it to your Thermok.

Startup Message

This is the message that displays when the Thermok is powered on. It can be up to 16 characters long.

Temperature Units

The Thermok can display temperatures in degrees Celsius or Degrees Fahrenheit. Data transmitted on the serial port (computer interface) is always in degrees Celsius. The temperature display units can also be changed by holding the red button while powering up the Thermok.

Degrees Celsius
Degrees Fahrenheit

Alarm Active State

In an alarm condition the thermok can make an output active high or active low.

Active Low
Active High

Over temperature set points

The Thermok has two optional over temperature outputs. You can control the set point for each channel independently. These set points are in degrees Celsius.

Output A

1:	2:
3:	4:

Output B

1:	2:
3:	4:

Generate Firmware

APRS World, LLC - Contact Us